Pintar - compact 4x5” field camera. 3d printed about 90% . Camera construct for shutters #00, 0, 1 and widespread Graflex film holders 4х5. Approximately 100mm to 300mm lenses accepted.Modular design allows for easy modifications and quick part replacements. Front Standard Rise/Fall (35mm/35mm), Shift (35mm each way), Swing and Tilt. Rear Standard Tilt and Swing only. All Swing and Tilt movements are only limited by the bellows.
Ground glass and lens board are quickly installable on neodymium magnets.
Weght without lens only 0.6kg,
Ground glass and lens board are quickly installable on neodymium magnets.
Weght without lens only 0.6kg,
Some photos of finished version of the camera
And some information of the camera and steps of creation
The Pintarcam is portable and quickly folding to small bag. Size in the folded state 190x190x80мм.
And as well lay out to flange focal distance 100 - 180mm. To adjust over 180mm need use focusing screw.
Camera includes all movements: Shift, Tilt, Raise-Fall, Swing.
The movements make it possible to solve otherwise impossible depth-of-field problems, and change perspective rendering, and create special effects that would be impossible with a conventional fixed-plane fixed-lens camera.
The movements make it possible to solve otherwise impossible depth-of-field problems, and change perspective rendering, and create special effects that would be impossible with a conventional fixed-plane fixed-lens camera.
The "Pintar" camera consists of 32 printed parts. Since all the lightweight non-steel parts are created through 3D printing, replacing the parts is as easy as doing a new 3D print. 3d Printed using a fully recyclable PETG plastic filament which is very durable and dimensionally stable and Stainless Steel hardware.
Some images of process
