This is a support I designed to hold your Dremel rotatory tool in an upward vertical direction and used it in this position. Is made out of two pieces, a flat base in the rear and the tool holder, there are two versions of this holder, one uses the standard cap that comes with your typical Dremel tool, and the other uses the cap that comes with the Detailer's Grip Attachment 577 (The one in the pictures, if you don't own it, I can't recommend it enough, its super useful). You only need one!
The base can be nailed or screwed to a table, but I recommend use a cramp and don't drill your workstation. The two pieces can be held with a screw, or glue together. You can also print both pieces as one, but that will need a lot of support. I made for those occasions where you don't have both hands to hold the tools or need to do some precise grinding o vertical cuts.
I also made a grinding guide that works perfectly with any Dremel tool, is goes threaded on the head of the tool like the standard cap or other attachments as It's based on Dremel's own A576 Sanding/Grinding Guide to perform in the same way but with more space to work when combined with the vertical support.
Both designs are avalible here:
https://www.youmagine.com/designs/vertical-support-for-dremel-tool
https://www.youmagine.com/designs/dremel-vertical-guide
