TRIPLEX MODEL SHOE
We were instructed to create an exact replica of a laced shoe of our choice. The shoe can only be constructed using triplex board, glue and masking tape to create a 1:1 ratio of our shoe.
Activity 1: Full Model Shoe
I began my process by starting with the sole of the shoe. Building the base of the shoe flowed quite smoothly, although the gradient in the sole was quite challenging to replicate. The fabric parts of the shoe were pretty easy to build, but I did not manage my time well, as I ended up rushing to get the last pieces stuck on. I ended up using too much masking tape to get those smooth curves due to running out of time. I did the small details right at the end, such as the laces, the pattern of the sole, and the grommets. I did not enjoy doing the pattern at the bottom of the shoe, as I found it tedious and tricky to copy.
Half Shoe
For our second task, we were required to show a section through the item so that the interior aspects are visible only using triplex board, tape and glue.
Activity 2: Section View
the half shoe was a much easier process from the beginning. I had a better understanding of the materials and was able to pinpoint my low points and what I could improve on by analyzing the first shoe. I paid close attention to keeping the shoe clean and focusing on the details to make the shoe neater than the first one.
Activity 3: Tooling block
For our third task we were required to create an imprint of our chosen shoe, represented by the "male" side. The tooling block was to be no less then 5cm from highest point of the shoe cutout.
I struggled the most with the tooling block. Constructing the shoe from the inside was the easiest part, although the dimensions and which piece sticks in and out was really challenging as there is no direct reference. it was an interesting process to construct the cutout. i struggled to construct the box around it as I struggle with cutting straight lines.
