Installing a utility sink next to your washer can be a great addition to your home and highly useful under certain circumstances. Some people do think its old school and they aren’t much influenced with the appearance as well as need for old fashioned utility sink is less. Since the washers comes with automatic washers and drying options, people aren’t influenced with utility sink. But it can add value to your home and lend a special sort of usefulness. If you are thinking about fixing a utility sink next to washer, explore this article as well as visit sinkengineering.com to understand the nuances of having one at your home.

The utility sink has to be fixed after considering where you want it and where it will best to fit in. It is better to place it next to work areas such as close to washer as it has hot and cold water as well as a draining point.

When the dry wall is covering the wall behind washer and dryer, it is actually concealing plumbing lines. Removing key sections of drywall are prominent. You don’t have to remove the entire wall. Fish out the current supply and drainage points using a stud finder and select the place for utility sink. Slice through the wall using a utility knife and tape join fill sheet of drywall. Now turn out the drywall screws and prying back the sheet to remove safely remove the sheet.

Employ a 5/8 inch auger bit drill, make two holes in each stud which leads you to intended location of utility sink. Hammering metal stud protector plates should be used to cover front of each hole.

Source a copper pipe cutter to cut into washer’s hot and cold copper supply lines. Now insert a tee on each line and running two PEX lines in the holes of the studs to locate utility sink location.

Hook the washer drain hose to hook over the all of utility sink. The expelled water from washer starts to flow into the sink and get back to the standpipe.

Fix a hot and cold supply lines to copper stub outs. Employ bend supports to direct each pipe at 90-degree angle. Employ the speed square to square up the pipes.

Now turn the utility tub upside down and fix four legs to the tub basin at its bottom. Levelling feet is also important thing to consider. Shift the utility tub upright again and level it with the assistance of bubble level or other levelling option.

Utility sink has to be installed with drain trap which must be attached to the drain line. Fix two stub outs on the place. Now turn on the water to check whether all the connections are right.

Once the plumbing is done, install dry wall on the open wall.

You have successfully installed utility sink near washer.