If you feel stuck at any point of setup contact Linksys Support on +1-844-644-1710 Toll free. The Linksys Velop Mesh Wi-Fi System setup procedure is simple, but it's important to pay close attention to the instructions to guarantee a robust and dependable network in your house. The following is a general setup guide for a Linksys Velop system:

Note: Before you begin, make sure you have the following:

The Linksys Velop nodes.

A stable and active internet connection.

A mobile device (smartphone or tablet) with the Linksys app installed.

‘

Step 1: Unbox and Connect

After unpacking your Velop nodes, plug them into a power supply. Placing the first node close to your modem is advised.

Step 2: Install the Linksys App

Install the Linksys app on your smartphone after downloading it.

Step 3: Create a Linksys Account

If you don't already have one, open the Linksys app and register for an account.

Step 4: Start Setup

Launch the Linksys app and enter your account information to log in.

Step 5: Identify Nodes

The app will guide you to identify the nodes. 

Step 6: Connect to the First Node

Connect your mobile device to the Velop network.

Step 7: Configure the Wi-Fi Network

You will receive guidance from the app when configuring your Wi-Fi network.

Step 8: Add Additional Nodes (if applicable)

For the best coverage, strategically place the extra nodes.

Step 9: Firmware Update (if needed)

You might receive a request from the app to upgrade the Velop nodes' firmware. Maintaining the most recent firmware is crucial for both security and functionality.

Step 10: Enjoy Your Velop Wi-Fi

Once the setup is complete, you should have a strong and reliable Wi-Fi network throughout your home.

Please note that this is a general guide, and specific steps may vary depending on the Velop model and app version you're using. Always refer to the Linksys Support Team for the most accurate and up-to-date instructions for your particular Velop system. You can Contact Linksys Support at +1-844-644-1710 Toll Free.